Pay in 4 interest-free payments of $30.24 Learn more
Ships within 48 hours · Estimated delivery Aug 3 - Aug 8
actual product may vary slightly from image
it is recommended to feed the pump with water from the side of the vessel (rather than bottom) to minimize fouling in the spray ball
With a heat exchanger (unlike the spray method of other commercial condensers) the cooling water stream is not mixed with the brew vapor (and does not therefore contain any undesirable compounds such as DMS that are being removed from the wort)
two sanitary analogue temperature probes (measuring the temperature of it leaves the top of the fermenter and as it is returned at the bottom of the fermenter after it has been cooled)
224cm/88" ceiling recommended (244cm/96" with electric hoist)
Replacement LCD, Interface and Controller BREWHA actual product may vary slightlySafe and precise power output. This touchscreen is the replacement part for the wall mounted BREWHA Touchscreen Electric Brewing Power Controllers. Note: when installing, hand tighten bezel screws only until snug and do not overtighten (do not use a drill) or the screen might crack. Note: replacement interfaces are shipped without micro SD cards; these should be transferred over from existing controller assemblies The WiFi Module attaches to Gen 2